BC Biomedical ESU-2000 Series Guide Instrukcja Użytkownika Pobierz pdf (Strona 19)

The following is a breakdown of the parameters available in the configuration of the unit

and their available options:

System Setup Configuration

Parameter

Description

Range

Donut Atten

Selects the RF Current Transformer Attenuation in

Volts : Amp for the RF Donut being used.

Default = 0.1 : 1

0.1 : 1

1 : 1

Volts : Amps

Input Zero

Zeros the input circuitry based on donut being

used. Each donut can have a slightly different zero

offset. This function will eliminate the offset from

the readings. Press the SETUP key while this

parameter is selected to perform the auto –zero

function.

Press Setup

Input Range

Determines the input range.

Default = Auto

100 mV

1000 mV

Auto

Input Mode

(ESU-2050P Only)

Determines whether the unit continuously monitors

the Input Signal or looks for a Pulsed Input Signal.

Default = Continuous

Continuous

Pulsed

Load Resistance

Used for Power (Watts) calculation only. Can be

adjustable or set by a table of fixed resistors. (See

Load Selection and Load Table for more

information.)

Default = 500

0-6,500.0 ohms

Load Selection

Determines whether the Load Resistance

Parameter is adjustable by tenths of ohms or

selected from the Load Table. The Load Table is

created from the Load Resistance Values set in the

Factory Setup and the Load Sets. (See Load Sets,

Load Table and Factory Setup for more

information.)

Default = Table

Adjustable or Table

Power up with

Determines the power up mode of the ESU-2050.

The default mode shows a single mV parameter

display. Set this parameter to custom to display

the saved startup mode. Set this parameter to

Save current as custom to save the settings for the

next time power is cycled.

Default = Defaults

Defaults

Custom

Set Current as Custom

Num A/D Samples

Sets the number of A/D converter readings used in

each mV RMS computation. A higher setting

requires more computation and is slower, but

results in a more stable reading.

Default = 32,768

1024

2048

4096

8192

16384

32768

Display Averaging

Sets which display averaging parameter is to be

used. Three independent averaging modes can be

configured for optimum system performance.

Fast

Medium

Slow

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Komentarze do niniejszej Instrukcji

Brak uwag

BC Biomedical ESU-2000 Series Guide Instrukcja Użytkownika Strona 19

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola BC Biomedical ESU-2000 Series Guide