
uppercase and lowercase. Commands sent to the device are not case sensitive. Upper
case characters in the command summary table below are used to show the shortened
versions of the commands if available.
SA-2010-R Communication Command Summary
MVOLtage
DCURrent
ERESistance
EGROund
ENCLosure
LEARth
LLEAd
LISOlation
EXTernal
Mains Voltage
Device Current
Earth Resistance
Earth / Ground Leakage
Enclosure Leakage
Lead to Earth Leakage
Lead to Lead Leakage
Lead Isolation
External Measurement
No Leads Selected
n Lead only
All Leads Active
Receptacle Hot Lead Open
Receptacle Hot Lead Closed
Receptacle Neutral Lead Open
Receptacle Neutral Lead Closed
Receptacle Ground Lead Open
Receptacle Ground Lead Closed
Receptacle Polarity Forward
Receptacle Polarity Reversed (reverse
HOT/NEUTRAL)
Isolation Test ON
Isolation Test OFF
Set AAMI test load
Set IEC test load
Returns the units of Measure (Volts, Amps, uA, Ohms)
[Read Only]
Returns the latest measurement [Read Only]
Changes Mode Up one position
Changes Mode Down one position
Changes Output / Lead Select Clockwise
one position
Changes Output / Lead Select Counter-
Clockwise one position
Duplicates the HOT key press
Duplicates the Neutral Key press
Duplicates the Ground key press
Duplicates the Polarity key press
Duplicates the ISO Test key press
Returns Safety Analyzer Model [Read Only]
Returns Firmware Version [Read Only]
Komentarze do niniejszej Instrukcji